Search

1 to 10 of 10
Sort by

Discussion Reply
RE: Issue with internet speed customers PE juniper MX104

Hello; Thanks for your reply, find below the output you requested. Note I have tested also without class-of-service setup on edge interface (xe-0/0/0), the result was the same, all customers with bandwidth 1Gbit/s can't reach it on their down traffic. Currently all customers with 1Gbit/s...


Discussion Reply
RE: Issue with internet speed customers PE juniper MX104

Hello Alex, Thanks for taking time to reply me. @aarseniev wrote: Hello, Is the customer who has speed problems connected to this port (xe-0/0/0)? Customers are connected directly on SWITCH then SWITCH are connected to xe-0/0/0 (10Gbit/s) on MX104, as below ...



Discussion Post
Issue with internet speed customers PE juniper MX104

Hello, We are facing internet speed issue with customers whose last mile are connected on MX104. Let me indicate that, we have migrated those customers from Cisco 6500 as PE to Juniper MX104 as PE, since this migration, all customers with last mile link bandwidth is 1Gbit/s are unable to...


Discussion Post
Configure/commit issue

Hi all, When i applied a new configuration on my existing srx240, the commit button don't validate the new configuration, without any error message. And when i pass to CLI mode, and type "configure" i have the message below: root@--> configure warning: Clustering enabled; using private edit...



Discussion Post
IDP: FAIL OPEN (RESOURCE ISSUES) ?

Studying the NSS Labs report from April 2008 on the IDP800 series (http://nsslabs.com/intrusion-prevention/juniper-idp-800.html), I noticed the important test called "Fail Open (resource issues)". " 8.1.9 FAIL OPEN (RESOURCE ISSUES) Does the NIPS provide the ability to pass all traffic when...



Discussion Reply
RE: LACP between EX4200 and Cisco Cat2950

Hi, the problem is solved. You need to put the next command in, even if the remote switch has Fastethernet interfaces. " set interfaces ae0 aggregated-ether-options link-speed 1g" If somebody is interested in the full config from Cisco / Juniper, pls let me know. Thanks for the help ...