Community Home

Hi Innovators! Thank you so much for your active participation in our December post where we asked for your thoughts on the word "Cloud" in product names . Here's a sample of what your industry peers shared: And here's what the Juniper ...

Hello everyone! I apologize for not being around the last couple of weeks. I was out there traveling on the conference scene. First I was over in Paris for SD-WAN and SASE 2022 . I had a lot of fun on this trip and got to speak with a TON of people ...

You could use source based routing and have the guest WiFi prefix using a forwarding routing instance to go to the desired provider. A kb example is here. https://supportportal.juniper.net/s/article/SRX-Source-based-routing-configuration-example?language=en_US ...

After further review, the above configuration is removing the inner tag. What needs adjusted to retain this? Both tags are ether-type 0x8100. ------------------------------ Dan Graham ------------------------------

Currently, all outbound requests use our first BGP neighbor to get to the Internet. I'm interested in sending guest wifi traffic, all NAT'd to a single IP, to the Internet via the 2nd BGP neighbor. I'm assuming the best way to do this is to just statically ...

Hi, can 10.10.10.1 ping 10.10.10.2? If not, check these things... Make sure you are connecting the vQFX PFE (vFP) and RE (vCP) using the em1 interfaces on both pfe and re Check "show chassis fpc" and you should see slot 0 Online/Testing ...

Hello , I have two ports on Juniper switch connected to two ports on one Mikrotik router as a bridge and I want to configure the two ports on Juniper to be active and standby or active and passive because this Juniper Switch is stacked for redundancy ...