Routing

Can you add the following: set policy-options policy-statement ACCEPT term 1 from protocol bgp set policy-options policy-statement ACCEPT term 1 then accept And to verify: On R11, what is shared with/from neighbors? show route advertising-protocol ...

I added it to the PE routers and It did not worked. Something is preventing the route to be scattered. I remember building it in Cisco, but I'm having issues with Juniper ------------------------------ DAVID CRIOLLO ------------------------------

Hi David Can you add the following to the configuration: set protocols bgp group IBGP family inet-vpn unicast I think it's missing from your BGP core configuration. Please check if other families are needed there too. By default only inet-unicast ...

Hi Everyone, I'm building a L3vpn between these two MX routers, the OSPF adjacency is up between MW and CPEs, however. no routes are been shared. Attached configuration from both PE root@R11# show | display set set version 20191026.124700_builder.r1063854 ...

Looking for recommendations on which EVPN instance type I should be considering. I'm supporting the build-out of an SR-MPLS network and we have decided to move to EVPN for customer layer2 E-line and E-Lan requirements. We are excited about using EVPN ...

Hi Sheetanshu, Many thanks for the response. I eventually figured out what the issue was. I had forgotten, on that particular system, to remove another policy that had a "Reject" as the last statement and in the list of Policies under the BGP group, ...

Hi all, I'm doing an inter-vendor lab with Ericsson and MX routers. So far, I have everything working fine on the Ericsson side, but not that much on the MX. All real hardware, no virtualization. SIDs are 2001:db8:a:(x)::/64, where X is the ...