Routing

Yes, they are router reflectos oot@R22> show route table inet.3 inet.3: 5 destinations, 5 routes (5 active, 0 holddown, 0 hidden) + = Active Route, - = Last Active, * = Both 10.255.255.11/32 *[LDP/9] 00:10:41, metric 1 ...

Hi @flashover , The method " Install-nexthop" just can use if we using BGP-VPLS and BGP-L2VPN right? Incase we just use LDP-VPLS and L2Circuit so we cannot use "Install-nexthop" right? If we using "PSN-tunnel-endpoint" then we need to ...

For linking specific VPNs to MPLS LSPs you can use a few different solutions: Cross-connect The oldskool cross-connect (CCC): set protocols connections interface-switch [...] The CCC has a 1:1 mapping between LSP:VPN. Every VPN has its ...

Hi all, Let's say the current MPLS is signaling by using LDP and as we know the LDP is using IGP best path. We have other l2 traffic such as L2circuit, l2vpn and also EVPN. To steering the traffic then we must use RSVP-TE by create LSP path. But ...

Hi everyone, Let 's say we have Path finder controller and we are using SPRING based LSP . Will it be possible to use aut-bw on such LSP? Or we can only use auto-BW feature on LSP that are RSVP based? Much appreciated!! ------------------------------ ...

Ok I see that your BGP sessions are down. That's why the VPN routes are not exchanged... So you'll have to fix that first, I don't have an idea why they are down. You are learning loopback IP in the MX core. Maybe you can try a ping between them (including ...

Your two PE's in this example aren't configure to peer with each other but with 10.255.255.33 and 10.255.255.44. Are 10.255.255.33 and 10.255.255.44 route reflectors? Have you also enabled inet-vpn AFI on those? Or just peer .11 and .22 directly. ...