Routing

All the Junos platforms support ipv6, but there are differences in the details and Junos versions required. You can use the Juniper Feature Explorer site to confirm what features are supported. From this link > Select your platform > then the Junos ...

We are planning to replace our core routers from MX480 to PX100002-60C to expand the 100G port density. One of the requirements we have in our network is a support of dual stack for ipv4 and ipv6 addresses. My question is, do PTX10002-60C support dual ...

Good morning, After having posted this to the DataCenter community, and being "without response" for around 1 month, I thought this community might be a better bet (I couldn't see how to cross-post a post once it had already been published, hence ...

With all due respect I don't think you understand. I'm talking about what leaf1 is doing inside the L2 virtual switch. Traffic never reaches the PE. The vrf config is irrelevant here. Sent from my iPhone On 6 Sep 2024, at 06:34, FARID AKHUNDOV ...

Well, that RIB group takes routes from VPN7 RIB and imports it into VPN10 RIB. Therefore, to import routes from VPN10 RIB into VPN7 RIB, you should do the reverse. ------------------------------ FARID AKHUNDOV ------------------------------

Thanks for the reply, we were able to get it working both ways. In the first one we need to import the inet.0 in the inet6.3 and inet6.0 and in the second one we did not requerie to put the inet6.3 in the resolution rib, but as you said we need to put ...

Hi, This is a bit odd setup. First of all, why would you use GRE, if only st0.x interface should be sufficient? GRE will add additional overhead. Also, if you need to configure 2 IPSec tunnels, one via each ISP, then it would be much reasonable ...