Routing

 View Only
last person joined: 3 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Ask AI Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • Profile Picture

    RE: IP helper for PXE boot

    By: spuluka , 7 days ago

    This kb example outlines the process for local dhcp with direction to remote tftp for PXE process. https://supportportal.juniper.net/s/article/EX-Switch-DHCP-Configuration-for-PXE-Environment?language=en_US Another Avaya IP phone specific example ...

  • Profile Picture

    IP helper for PXE boot

    By: EMTSU , 8 days ago

    How do I configure an IP helper to direct traffic to a PXE boot server please?

  • Profile Picture

    Dual ISP routing on SRX 340 Cluster

    By: TAYO DADA , 8 days ago

    Unable to failover to ISP2 in case isp1 is down here is the config. Can you please help on how to get this working? "set groups node0 system host-name srx-a set groups node0 interfaces fxp0 unit 0 family inet address 172.16.2.5/24 set groups node1 system ...

  • Profile Picture

    eBGP Multihop and Routing Instance

    By: Anonymous , 16 days ago

    This message was posted by a user wishing to remain anonymous Hi all! I have a network (MPLS, OSPF, LDP, RSVP, BGP) consisting of several routers (R1–R5), two of which (R4, R5) act as Route Reflectors and are also connected to uplinks. BGP sessions ...

  • Profile Picture

    RE: Global Routing Table in a VRF

    By: CRAIG DALRYMPLE , 17 days ago

    I never meant to insinuate that it didn't. My point was that MWA may not be configuring a global OSPF instance, which makes sense as it is not needed in this use case. Stuart Ridsdale nailed my issue -- well sort of. After many years of working in ...

  • Profile Picture

    RE: MX204 configure 1G interface

    By: Odehflonic , 17 days ago

    You are correct, this approach worked perfectly in my environment. Thanks ------------------------------ IDOKO ODEH ------------------------------

  • Profile Picture

    RE: Global Routing Table in a VRF

    By: Sheetanshu , 17 days ago

    Hi Craig, As discussed in the thread you raised ( thread link ), the receive-protocol command is not valid for OSPF, regardless of the routing instance configuration. Mist Wired Assurance does not restrict the use of show commands on the switches. ...

Announcements

  • Tell us if you've upgraded or if you need help upgrading!

    Complete this three-question survey to help us identify where you are in your upgrade journey.

Unanswered Posts

  • Dual ISP routing on SRX 340 Cluster

  • eBGP Multihop and Routing Instance

  • MX480 DHCPv6 Relay - Cant ping loopback address, and ...

  • MX Virtual Chassis VCP Upgrade (4x10G to 3x40G)

  • MX Tunnel-services bandwidth command

  • EVPN-VPWS over SRv6 not working due to KRT queued ...

  • Inter-domain sr-te lsp just dont comes up

Top Contributors in the Community