Routing

The source of the bandwidth request to RSVP will be the path configuration for the LSP. You choose the level of bandwidth request which can be the same for different for the primary and backup path. RSVP will then calculate the primary and backup path ...

Hello guys! I've worked with RSVP-TE on Juniper devices and I know that devices support link protecion with aditional node protection, but I didn't find out anything about aditional bandwidth protection (Bandwidth protection desired: 0x08) as described ...

This message was posted by a user wishing to remain anonymous Team, gateway device connected to Juniper device ( not sure directly or not), however i have IP of gateway device. I would like to understand below CLI output to know the connectivity. ...

CGNAT on MX is what I implemented for an ISP of 50,000 subscribers. Mainly residential broadband and some businesses also. FTTH mainly, with some cable modem and dsl. We tested and implemented in ~2018. We first did MX104's with MS-MIC-16G for ~4,000 ...

Hi, I need to provide a solution for CGNAT service in a ISP network. I have to provide a method to chose the correct SRX (or a MX with the right number of MX-SPC3). what are the correct number to ask for? number of clients (fixed and mobile)? number ...

Hi Farid and thank you for reply... It's maybe a bit weird setup, but in the reality MX sits between two infrastructure (et-0/0/0, xe-0/1/4), not just between few hosts and i have to have transparent L2 in the same vlan in which there is a bgp peers. ...

I have now a other question, thanks to this Framed-IPv6-Prefix, my CPE have access to internet, but my LAN don't. I know that we can share a /56 or /48 from RADIUS Delegated-ipv6-Prefix. Then, we can try to "preconfigure" WAN interface to CPE to use ...