Routing

 View Only
last person joined: 2 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • Hello, I have a bunch of branch SRXes, one central SRX650 and an MX5 router with MS-MIC that I set up the tunnel from to the central SRX. The SRX bunch is performing well via st tunnels, but I'm struggling with the ipsec performance on the SRX-MX ...

  • Hi. I have an MX route reflector that is receiving both L3VPN and IPv4 routes from a client. How do I configure the route reflector to only reflect the L3VPN routes and not the inet.0 routes? Is there a way to do this without configuring multiple ...

  • If you are trying to be more conservative with your address and port use, and you know that 4096 ports per customer (512*8) is more than enough, then you could carefully walk that back. like, maximum-blocks-per-host 6, and see if this allows you to ...

  • What is the JunOS version / model? :) ------------------------------ Olivier Benghozi ------------------------------

  • Well to be entirely fair, it is possible but you'd have to deactivate configuration, as mentioned above by Sheetanshu . Either you'd have to deactivate the entire IRB and the statement under the VLAN where you define the l3-interface, or you'd have ...

  • Thanks for such a comprehensive response. As part of a change its really useful to pre-stage config ( just one less thing to do on the night ) with just one thing disabled/or deactivated. then the change can simply be disable the old, enable the new ...

  • Thanks Aaron, I will need to lab it up now just to see, but this was service effecting to the network I was configuring !! the IRB was actually a gateway on a LAN if it was responding arp or if the VIP was up ( not shown in my example ) this would have ...

Announcements

Unanswered Posts

  • 1 person recommends this.

Top Contributors in the Community