View Only
last person joined: yesterday 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • This message was posted by a user wishing to remain anonymous Team, gateway device connected to Juniper device ( not sure directly or not), however i have IP of gateway device. I would like to understand below CLI output to know the connectivity. ...

  • Profile Picture

    RE: CGNAT sizing

    CGNAT on MX is what I implemented for an ISP of 50,000 subscribers. Mainly residential broadband and some businesses also. FTTH mainly, with some cable modem and dsl. We tested and implemented in ~2018. We first did MX104's with MS-MIC-16G for ~4,000 ...

  • Hi, I need to provide a solution for CGNAT service in a ISP network. I have to provide a method to chose the correct SRX (or a MX with the right number of MX-SPC3). what are the correct number to ask for? number of clients (fixed and mobile)? number ...

  • Hi Farid and thank you for reply... It's maybe a bit weird setup, but in the reality MX sits between two infrastructure (et-0/0/0, xe-0/1/4), not just between few hosts and i have to have transparent L2 in the same vlan in which there is a bgp peers. ...

  • I have now a other question, thanks to this Framed-IPv6-Prefix, my CPE have access to internet, but my LAN don't. I know that we can share a /56 or /48 from RADIUS Delegated-ipv6-Prefix. Then, we can try to "preconfigure" WAN interface to CPE to use ...

  • Indeed, as already mentioned, as-path-prepend is to (possibly) control traffic, ENTERING your ASN. To manipulate exit point FROM your ASN, try to set highest localpref for the needed neighbor. Worth mentioning that in case you set highest localpref ...

  • I have deleted " Framed-IPv6-Address" from radius and added set dynamic-profiles DP_PPPoE_L2_IPv6 protocols router-advertisement interface "$junos-interface-name" prefix $junos-ipv6-ndra-prefix IPv6 in now working well. Thank you ...


  • AI-Driven Support via JSI

    Get AI-driven support by connecting your devices to Juniper Support Insights (JSI). Join one of our upcoming “Jumpstart JSI Ask the Experts” meetups to learn more about JSI and ask the panel of experts your questions. Select the session that best suits your schedule:

    Tuesday, June 25 from 8:00-8:45PM PT: Register Now
    Wednesday, June 26 from 8:00-8:45AM PT: Register Now

Unanswered Posts

Top Contributors in the Community