Routing

 View Only
last person joined: 2 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • With CoS you need to mark on egress and process on ingress. So if you need the queuing to occur in both directions of the flow then it would need to be setup on all devices that the flow crosses. ------------------------------ Steve Puluka BSEET - ...

  • I do not have any comment about the FBF, but note that it is possible to return the name of the routing-instance from RADIUS, so you should not need to do FBF. /Per ------------------------------ PER GRANATH ------------------------------

  • Hi everyone, I am wondering if Juniper supports Shadow RR and BGP shadow session . Thanks. ------------------------------ Be kind!! ------------------------------

  • Hi, there is a CLI knob "vpn-unequal-cost" (https://www.juniper.net/documentation/us/en/software/junos/cli-reference/topics/ref/statement/vpn-unequal-cost-edit-routing-options.html), however it's for a VRF scenario so it would need some changes in your ...

  • Hi, I have an MX960 configured as a BNG with two VRFs: one for subscriber access and another for Internet access. Some subscribers have static public IP addresses assigned by Radius, and their traffic needs to be forwarded directly to the Internet VRF. ...

  • Hi all, I'm see this url https://www.juniper.net/documentation/us/en/software/junos/cos/topics/example/tunnel-cos-example-cos-config-guide.html is it just need to configure at one side only?The current device in my network was MX480 and MX240. The ...

  • Hi, I'm using an MX204 with JunOS 22.2R3-S2.8 and I need to enable BGP load sharing on my crosslink which uses iBGP. When I started lab testing I couldn't manage to do it, then I found this documentations which describes the " allow-external-internal" ...

Announcements

Unanswered Posts

Top Contributors in the Community