Routing

 View Only
last person joined: yesterday 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Technical Bulletins Knowledge BaseDay One+

Latest Discussion Posts

  • Profile Picture

    RE: SRX PBR (or FBF) for retrurn static routing

    By: OUSMANE NATHA DIARRA , 3 hours ago

    Explaination : when the packet is initiating from ip 10.232.0.132/32 locate on vsys internet to the ip 10.172.19.15 behind the SRX via reth0.600, the return packet is going toward reth0.910 instead of reth0.600. I would like the return trafic to ...

  • Profile Picture

    RE: SRX PBR (or FBF) for retrurn static routing

    By: OUSMANE NATHA DIARRA , 3 hours ago

    Explaination : when the packet is initiating from ip 10.232.0.132/32 locate on vsys internet to the ip 10.172.19.15 behind the SRX via reth0.600, the return packet is going toward reth0.910 instead of reth0.600. I would like the return trafic to ...

  • Profile Picture

    RE: SRX PBR (or FBF) for retrurn static routing

    By: spuluka , 12 hours ago

    If you just want to insure return routing on the SRX a simple method would be to enable source nat translation to the interface for the inbound flow. Then the traffic internal to the network will be routed back to the SRX interface address and match ...

  • Profile Picture

    RE: SRX PBR (or FBF) for retrurn static routing

    By: Sheetanshu , 17 hours ago

    Hi, Can you please share a topology, IP addresses of the source and server and the output of "show route <server-ip>" and "show route <client-ip>" from the SRX in question? Regards ------------------------------ Sheetanshu Shekhar ----------- ...

  • Profile Picture

    BGP OVER IPSEC SOLUTION WITH AWS AND SRX5800

    By: OLALEKAN AJAYI , 19 hours ago

    i need help on why i keep getting packet loss on the secure tunnel interface with aws , Attached is my configuration file and ping test below PRIMARY TUNNEL ping 169.254.170.121 source 169.254.170.122 routing-instance internet-vr rapid ...

  • Profile Picture

    SRX PBR (or FBF) for retrurn static routing

    By: OUSMANE NATHA DIARRA , 21 hours ago

    Hi All, I would like to configure a FBF to specify a return traffic next hop in order to avoid the an asynmetric routing. The return packet from the serveur when reach the srx takes a different route (interface) instead of the interface that the ...

  • Profile Picture

    PACKET LOSS ON A SECURE TUNNEL P2P IP ( JUNIPER AND ...

    By: OLALEKAN AJAYI , 21 hours ago

    Hello , I need a support to resolve packet loss issue with an AWS instance BGP over IPSEC setup. On my end is SRX 5800 , other end is AWS instances The set up was BGP over IPSEC setup. Here is the problem statement Packet loss on the primary ...

Announcements

Unanswered Posts

  • BGP OVER IPSEC SOLUTION WITH AWS AND SRX5800

  • PACKET LOSS ON A SECURE TUNNEL P2P IP ( JUNIPER AND ...

  • MPLS L3VPN TTL problem

  • Question on Segment Routing Shared Fate Groups

  • Question on Segment Routing L-OSPF Route Protocol ...

  • P2MP traffic loss over QFX and EX series

  • dhcpv6 relay and demux0

Top Contributors in the Community