Routing

 View Only
last person joined: 8 days ago 

Ask questions and share experiences about ACX Series, CTP Series, MX Series, PTX Series, SSR Series, JRR Series, and all things routing, including portfolios and protocols.

If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge! Post here or in the vMX community. 

Need additional guidance?  Check out these Juniper Resources.

Documentation Technical Bulletins Knowledge Base Day One Books

Latest Discussion Posts

  • Hi James 4 x 100G on the MX204, and remember to reload. set chassis fpc 0 pic 0 pic-mode 100G set chassis fpc 0 pic 0 port 0 number-of-sub-ports 1 set chassis fpc 0 pic 0 port 1 number-of-sub-ports 1 set chassis fpc 0 pic 0 port 2 number-of-sub-ports ...

  • Hi James To enable 4 x 100G on the MX204 use this and reboot :-) set chassis fpc 0 pic 0 pic-mode 100G set chassis fpc 0 pic 0 port 0 number-of-sub-ports 1 set chassis fpc 0 pic 0 port 1 number-of-sub-ports 1 set chassis fpc 0 pic 0 port 2 number-of-sub-ports ...

  • It's been a while since I first started working with the MX204 from years ago, so I don't recall the growing pains/learning curve I had to climb as to why I do what I do now... but I do have a standard initial config from my 204's similar to what you ...

  • Note that you can use maximum 400G of total port capacity. MX204 Port Checker | Juniper Networks Pathfinder ------------------------------ PER GRANATH ------------------------------

  • Georgi This is a physical MX 204. We were able to get the interfaces up and config, but setting the speed for all interfaces. All the examples I found online and what I tried was to set: set chassis fpc 0 pic 0 port 0 speed 100g set chassis ...

  • How about sharing the hardware details? Best e-gards, Georgi Sinapov Core Network Architect

  • Good morning I am working to enable 100Gig interface on our MX204. I have found community documentation online referencing the commands below and then offline and online commands. I keep getting an error message after offline /online about invalid ...

Announcements

  • Introducing Juniper Support Portal (JSP) Mobile App for iOS

    The Juniper Support Portal (JSP) Mobile App is now available for customer use on iOS platforms. The app is designed to provide mobile access for on-the-go service support. 

    What’s available?

    • Live Chat Support
    • Instant Notifications
    • Knowledge Base Access 

Unanswered Posts

Top Contributors in the Community