Routing

If the session is initiated by 10.172.19.90, this solution should work. This solution should also have worked had it been applied on an MX instead of SRX. If the session is initiated by 10.239.10.11, then please try applying the following filter on ...

Hello, I have a forwarding type routing instance which i leak all routes from a BGP group and even though the routes are in the table when i ping using the instance i get the error: "ping: sendto: Can't assign requested address" Here is the ...

Hi, I did the change but still not working set firewall family inet filter PBF-Filter term 1 from source-address 10.239.10.11/32 set firewall family inet filter PBF-Filter term 1 from destination-address 10.172.19.90/32 set firewall family inet filter ...

This message was posted by a user wishing to remain anonymous https://www.juniper.net/documentation/en_US/release-independent/nce/topics/example/mpls-vpn-option1-configuration.html Juniper Example: Configuring ...

I believe you need to add the protection revert timer to the configuration as outlined here. https://www.juniper.net/documentation/us/en/software/junos/mpls/topics/ref/statement/protection-revert-time-edit-protocols-mpls-interface-static.html ------------------------------ ...

Hello, I'm using a template for dynamic-tunnel (here is the template): label-switched-path lsp-template-ad-frr { template; adaptive; fast-reroute; } And here is the use of that template under routing-options: dynamic-tunnels ...

In the below firewall filter, swap the source and the destination address. Also apply the firewall filter on the interface ge-0/0/1 rather than ge-0/0/0 set firewall family inet filter PBF-Filter term 2 from source-address 10.239.10.11/32 set firewall ...