SRX

Hello,

my SRX300 says that it boots from the backup partition:

***********************************************************************
** **
** WARNING: THIS DEVICE HAS BOOTED FROM THE BACKUP JUNOS IMAGE **
** **
** It is possible that the primary copy of JUNOS failed to boot up **
** properly, and so this device has booted from the backup copy. **
** **
** Please re-install JUNOS to recover the primary copy in case **
** it has been corrupted and if auto-snapshot feature is not **
** enabled. **
** **
***********************************************************************

but when I issue the commands:

- show system alarms
No alarms currently active

- show chassis alarms
No alarms currently active

I recall on the srx100, srx210 и srx240, the same command would render:

• show chassis alarms
  2023-03-17 10:34:46 MSK Minor Host 0 Boot from backup root

Is that the 'default' behavior for the SRX 300 ?

That's surprising. I have a 340 which did raise a minor alarm about this not too long ago.  If you have auto-snapshot enabled, though, you wouldn't get an alarm.

Hello,

my SRX300 says that it boots from the backup partition:

***********************************************************************
** **
** WARNING: THIS DEVICE HAS BOOTED FROM THE BACKUP JUNOS IMAGE **
** **
** It is possible that the primary copy of JUNOS failed to boot up **
** properly, and so this device has booted from the backup copy. **
** **
** Please re-install JUNOS to recover the primary copy in case **
** it has been corrupted and if auto-snapshot feature is not **
** enabled. **
** **
***********************************************************************

but when I issue the commands:

- show system alarms
No alarms currently active

- show chassis alarms
No alarms currently active

I recall on the srx100, srx210 и srx240, the same command would render:

• show chassis alarms
  2023-03-17 10:34:46 MSK Minor Host 0 Boot from backup root

Is that the 'default' behavior for the SRX 300 ?