Hi ,
I used SRX380 to establish a cluster. After confirming that it was normal, I inserted two SFP and two SFP+.
The original plan was to set reth to xe-0/0/17 xe-0/0/18, but it was deleted for other reasons and replaced with ge-0/0/14 ge-0/0/15.
After I adjusted this setting, the xe-0/0/17 xe-0/0/18 LED lights were always on, and the interface in the simple interface showed UP.
Gbic is buy Juniper 1Gb and 10Gb. I've tried plugging the Gbic back in.
Is there a PR number? I think this should be a bug.
Junos Ver: 21.4R3-S4.9
node0:
--------------------------------------------------------------------------
Hardware inventory:
Item Version Part number Serial number Description
Chassis SRX380-POE-AC
Routing Engine REV 06 650-097090 RE-SRX380-POE-AC
FPC 0 BUILTIN BUILTIN FPC
PIC 0 16xGE,4*SFP+ Base PIC
Xcvr 16 REV 02 740-011613 SFP-SX
Xcvr 17 REV 02 740-011613 SFP-SX
Xcvr 18 REV 01 740-021308 SFP+-10G-SR
Xcvr 19 REV 01 740-021308 SFP+-10G-SR
Power Supply 0 REV 04 640-060602 JPSU-600W-AC-AFO
node1:
--------------------------------------------------------------------------
Hardware inventory:
Item Version Part number Serial number Description
Chassis SRX380-POE-AC
Routing Engine REV 06 650-097090 RE-SRX380-POE-AC
FPC 0 BUILTIN BUILTIN FPC
PIC 0 16xGE,4*SFP+ Base PIC
Xcvr 16 REV 02 740-011613 SFP-SX
Xcvr 17 REV 02 740-011613 SFP-SX
Xcvr 18 REV 01 740-021308 SFP+-10G-SR
Xcvr 19 REV 01 740-021308 SFP+-10G-SR
Power Supply 0 REV 04 640-060602 JPSU-600W-AC-AFO
------------------------------
GARY WU
------------------------------