Hi all,
I am testing some Juniper devices for possible use as NTE for the Ethernet Core.
I configured and tested the SRX300 and that works fine. I am now configuring an SRX340 and have hit a problem.....
I have configured the following for Interface ge-0/0/5:
set security zones security-zone trust interfaces irb.10
set interfaces ge-0/0/5 unit 0 family ethernet-switching interface-mode trunk
set interfaces ge-0/0/5 unit 0 family ethernet-switching vlan members v10
set interfaces irb unit 10 family inet address 100.100.100.2/30
set vlans v10 vlan-id 10
set vlans v10 l3-interface irb.10
Okay. So, that is the configuration, but the error is even more strange.
The cat5e cable connected to port 5 connects to our Core MX router. Hence the requirement of the VLAN. When I physically connect this canle the physical layer Green lights do not come on. In fact, it does not matter what port I attach this cable to, the port lights do not come on. When I attached this same cable back to the SRX300 it all worked fine. So I know there is nothing wrong with the cable and the config is the same as the SRX300.
Anyone got any ideas with this?