set interface ethernet2/3 dip 4 10.30.250.5 10.30.250.5
It is pool based source nat , but here the dip pool consists of only one ip
This command Creates a dip object with the ip 10.30.250.5 on the interface e2/3
After that you will find that this dip is mentioned at some policies like the below :
set policy id 5 from "IP-1" to "IP_2" "HTTP" nat src dip-id 4 permit
So , The natting steps are :
1- create dip address on the outgoing interafce
2-mention the dip at the policy
************ Mark My Post as Accepted if it solved your problem By clicking on the button saying " Accept as Solution " ************