Hi everyone,
This is the message the output of the firewall device from console when trying to boot up.I hope this piece of information will be of help.
ScreenOS Boot ROM v3.32 (Build 366D)
(c)1997-2000 Netscreen Technologies, Inc. All rights reserved
RM7000 CPU, Revision 33
16KB I cache, 16KB D cache
256KB Secondary Cache
Detect SDRAM (0C,0A,04,02)...... 256MB SDRAM, 2 Banks
SRAM OK!
Config Ethernet Device
Done!
NetScreen Technologies, Inc
NetScreen 500 Load Software
Copyright, 1997-2001
Version 1.9
Hit any key for Boot/Diag mode
Hit any key for Boot/Diag mode
Hit any key for Boot/Diag mode
Hit any key for Boot/Diag mode
Load System Image From Flash
********ignore image authentication!
Load image to address 0x80060000
Start loading...
....................................................................
Done.
Juniper Networks, Inc
NS-500 System Software
Copyright, 1997-2004
Version 5.00r9.0
Init Heap (1660010/cf9fbf0,32, 00000000/00000000)
Rev.D Sagittarius board
GT64120 revision id: 0x11
Load NVRAM Information ... (5.0)Done
Detected SRAM memory size 1048576
Memory Test: b7800000,100000 .......Memory Address Test failed at b7800004: b780
0044
Memory Address Test failed at b780000c: b780004c
Memory Address Test failed at b7800014: b7800054
Memory Address Test failed at b780001c: b780005c
Memory Address Test failed at b7800024: b7800064
Memory Address Test failed at b780002c: b780006c
Memory Address Test failed at b7800034: b7800074
Memory Address Test failed at b780003c: b780007c
Memory Address Test failed at b7800084: b78000c4
Memory Address Test failed at b780008c: b78000cc