Hello ,
I have a two SRX 380 boxes and i have to configure clustering
by default all ports are in irb unit 0
i want to use Ge-0/0/5 as control port and Ge-0/0/6 +Ge-0/0/7 as fabric ports . i will connect these interfaces upfront
I will run below commands
on node A
srx1>set chassis cluster cluster-id 1 node 0 reboot
on Node B
srx2>set chassis cluster cluster-id 1 node 1 reboot
Do i have to remove Ge-0//05 ge-0/0/6 Ge-0/07 from IRB before running the above commands ?
If yes , how to do this ?
If i have to use any other interface for reth , do i have to everytime first remove the interface from IRB ?
is there a global command which can be run to remove all interfaces from irb unit 0?