The nat will have to be done on the device that actually has the public ip address. If the SRX locally has only RFC 1918 private addresses then the nat cannot occur on any of them.
Are you managing the public ip device or is that a service provider equipment?
------------------------------
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP - Retired)
http://puluka.com/home------------------------------
Original Message:
Sent: 11-15-2023 20:27
From: DIEGO GALVANI
Subject: Allow access to the SRX
Hi, I have a scenario that I'm having doubts about. I need a single IPv4 (177.x.x.x) to have access to my SRX and that this IP can also access all 10.0.0.0 networks that each SRX has. How should I grant access to this IP on each SRX..
Please ,can anyone help me?
------------------------------
DIEGO GALVANI
------------------------------