Switching

Yup, that was it. I had a problem with this before and thought it wasn't working, but that was a problem with xe vs et interface prefix. Static route works. Thanks! ------------------------------ JONATHAN SINCLAIR ----------------------------- ...

Hi Pavel you do not need a license, but it will give you a warning when you commit. Configure it and OSPF will work

Hi Jonathan, Maybe you could add a route like this on switch 1 and switch 2: set routing-options static route 0.0.0.0/0 next-hop 10.1.101.1 That would impact traffic on the DCMgmt vlan but would not impact traffic flowing through the switch on other ...

That is right, on access ports you can set one VLAN as member, try one with IRB so you can ping EX4300 from laptop on IP .3 for example. i.e port 22 vlan 20, port 23 vlan 24 etc then your trunk port 24 device , i.e router would have .1/24 IP you ...

I tested this in a lab but nobody recommended it for prod: A1-LAB> show configuration interfaces et-0/0/31 description "c03 / virtual"; flexible-vlan-tagging; native-vlan-id 10; mtu 9216; encapsulation flexible-ethernet-services; unit 10 { description ...

Can you please tell me if EX4300 works with OSPF by default or do I need to buy a license? ------------------------------ Pavel Guegan ------------------------------

I have two EX4100s in a VC that are handling routing for a building. There are other EX4100s in different closets around the building that are trunking all VLANs to the VC. VC <-fiber-> Switch1 <-fiber-> Switch2 <-fiber->Back to VC. The VC has fiber ...