Good Day Marcel
I just created a lag through the GUI as I do not really have experience on the Juniper units. On the FortiGate's I created a new 802.3ad interface but when doing it on the Junipers the link does not come up so essentially, I am looking for assistance on setting it up through cli.
Many thanks
Cornelis
------------------------------
CORNELIS MUILWIJK
------------------------------
Original Message:
Sent: 06-10-2024 04:13
From: MarcTB
Subject: LACP setup between Fortigates and Juniper EX3300
Good Morning Cornelis,
Two questions:
- Are you able to share your configurations for the interfaces ? This will make it a bit more easy for people in the community to help you.
- Did you try auto negotiation on both sides ? Or did you put the interfaces into full-duplex 1000 mbit
Thanks
Marcel
------------------------------
Marcel ten Berg
http://www.juniper.net
Original Message:
Sent: 06-09-2024 05:11
From: CORNELIS MUILWIJK
Subject: LACP setup between Fortigates and Juniper EX3300
Good day
I am trying to setup a LACP link between our Fortigates 200f's (which is in HA active-pasive) and Juniper EX3300 switches however the link does not come up. Could someone please guide on the correct setup for the LACP link from Fortigate to port ge-0/0/41 and port ge-1/0/41 please.
Many thanks
------------------------------
CORNELIS MUILWIJK
------------------------------