Switching

Hi Johnny, Sorry you are having trouble with this initial setup. If the device is in factory default this should be as straightforward as you expected. I see your interface irb.0 has an interface 192.168.1.97, is this the IP you configured manually? ...

This might be this software bug outlined in PR 1406242. https://prsearch.juniper.net/problemreport/PR1406242 What is your Junos version? ------------------------------ Steve Puluka BSEET - Juniper Ambassador IP Architect - DQE Communications ...

Hi everyone, I have a pair of EX4300 in VC mode that is running version 18.1R3-S6.1 Member 0 is the master. Before the issue occurred, there were a lot of logs below: 10:45:30 pfex: CMLC: Error writing 'CM FPC status' msg to Master 10:45:30 ...

You got the point: in order to have multicast streams only sent where they are wanted, you use L3 and route (and use PIM-SM on the L3 routing, and IGMP in each (v)LANs). Another argument against big LANs, actually. ------------------------------ ...

Hi Gavin, Thanks for reply. ex3400 rear con port connect to pc, rear MGMT port and front ge-0/0/0 port and pc port all connect to another switch which has a DHCP Server connected, the ex3400 seems didn't get an IP, so I tried to configure ...

Hi Johnny, The Graphic you shared shows that nothing is connected to the switch. Typically the default configuration will allow the switch to obtain an IP address via DHCP on the default vlan. This is applied to irb.0. You would use this IP address ...

Tring to use network conntect (web ui) to a new ex3400 but failed. first using a pc connect to ex3400 console port, after using EZsetup or configure mode command, none can connect to ex3400 web ui https://www.juniper.net/documentation/us/en/quick-start/hardware/qsg/ex3400/topics/topic-map/step-2-up-and-running.html ...