Routing

You are correct the designations from low to high indicate where dropped traffic should occur first at times of contention. This overview gives a good set of descriptions for the overall settings that get configured to apply CoS overall. https://www.juniper.net/documentation/us/en/software/junos/cos-security-devices/topics/task/cos-device-configuration-overview-security.html ...

Hi, I am working on CoS and I do not understand well what does loss-priority do exactly? What is the relation between increasement from low priority towards high priority and packet loss desired? For example if I set high for the classifier does ...

Please advise on Junos version and BGP configuration for that peer. Have you tried capturing the egress BGP on the SRX with monitor traffic | Junos OS | Juniper Networks to ensure it's not corruption on the wire or by the receiver?

Thanks Farid, I will give a try with IP, I followed the instruction below that says next-hop has to be interface . I will let you know. https://www.juniper.net/documentation/us/en/software/junos/cos/topics/concept/cos-configuring-cos-based-forwarding.html ...

Hi I have a router MX204, found "Dropped traffic statistics due to STP State" in a interface, but stp is disable at global level at both side, the interface diagnostics optics is normal, what cause dropped traffic? show interfaces et-0/0/2 ...

Hi all, We have 2 MX10003 with MPiBGP between them (ospf, ldp, bfd, ibgp) . JunOS version : Junos: 23.4R1.9 We have some VRFs in the MXs and we have a static route +bfd to Net1 in MX1 vrf1. The static routes have bfd and it is UP/Active ...

Hi, Does anyone already faced one issue related to SRX300 sending malformed BGP OPEN messages, without marker, type and so on. We only see the following pattern in the TCP payload: 12 03 AB CD. These packets cause the remote peer to drop the connection ...