Routing

This message was posted by a user wishing to remain anonymous Hello all, Hope your day is going well. Query: On Cisco device you can use the configuration "encapsulation default" on subinterface. The behaviour is that that subinterface/flow ...

Hi Farid, We can use the keyword exact here----> route-filter 10.16.15.0/24 exact. This would match the prefix 10.16.15.0/24. Regards ------------------------------ Sheetanshu Shekhar ------------------------------

Hi Mohammad Ali, The selected protocol should be direct in place of OSPF, in the screenshot that has been shared. The policy configured on the Mist portal will show up in the device config only when it is applied as an export/import policy in a ...

Hi, So, the correct way would be something like set groups top policy-options policy-statement ospf-export term 1 from protocol direct route-filter 10.16.15.0/24 prefix-length-range /24-/24 set groups top policy-options policy-statement ospf-export ...

NOTE: I'm guessing the Mist UI Routing Policy section is doing the same. But I don't have the OSPF license so I can't tell. ------------------------------ MOHAMMAD ALI ------------------------------

Thank you both for your help, makes sense. So I have this sample code and looks like between the commands I posted and what y'all posted I can accomplish most of it. router ospf 1 router-id 10.30.15.254 log-adjacency-changes detail ...

In addition to previous comment, considering that groups are being used, something below can be configured set groups top policy-options policy-statement ospf-export term 1 from protocol direct set groups top policy-options policy-statement ospf-export ...