Routing

Hi, I would suggest to try 2 things Try to use IP address instead of interface as next-hop in COS forwarding policy. In policy statement itself, I think accept action is unnecessary for T1 term, just COS next-hop-map should be enough. ------------------------------ ...

In case next hop of the received prefix from eBGP neighbor is not reachable, it will not be accepted. Even if you apply import policy to fix the next hop, the prefix needs to first be ACCEPTED, after which its next can be modified. Classic example is ...

Hi Marc, I know it is old thread but it contains a lot of valuable info. By default, Junos OS does not maintain the route for indirect next hop to forwarding next-hop binding on the Packet Forwarding Engine forwarding table... .so that is why ...

Yes, so you just have to set chassis fabric redundancy-mode increased-bandwidth and that's it. It's still redundant, it's just that in case of failure of one SCB board your bandwidth would suddenly be limited. ------------------------------ Olivier ...

Hi everyone, I am trying to understand class based forwarding, I have built a sample topology in EVE-NG SRX is running in packet mode. We are running OSPF between SRX1 and SRX2 on all interfaces ( ge-0/0/0, ge-0/0/1, ge-0/0/2, ge-0/0/3). SRX1 ...

Hi, The input filter name suggests a 20Mbps limit with a 2048k burst size. So yes it is likely the problem as it probably has a 20Mbps policer in that filter. Do you have another input filter for 50Mbps? If there is not already one created, I would ...

Hi Dhikra, I assume your eBGP neighbour is connected to ge-0/0/0.0. Can you show the configuration of ge-0/0/0.0 ? The log message suggests the interface the router was using went down, or is no longer available in this VRF. Regards, Matt ...