Screen OS

 View Only
last person joined: 10 months ago 

This is a legacy community with limited Juniper monitoring.
  • 1.  Policy Based VPN

    Posted 12-05-2007 03:37
    Dear All,
    i used to configure policy based vpn from long time ago without any problems, i'm confused here that these days its not working unless i enable RIP on the trust interface !! which i do remember (or maybe i'm wrong)that i dont need to enable it !! anyone can help me please.. should the policy based VPN work without enabling RIP on the trust zone.. !!!
    #config
    #policy
    #RIP
    #vpn
    #based
    #routing
    #configuration


  • 2.  RE: Policy Based VPN

    Posted 12-05-2007 14:39
    RIP is most definitely NOT required for policy-based VPNs. What error are you seeing in event log? Can you post relevant configs? In particular, IKE, VPN and tunnel policy configs.


  • 3.  RE: Policy Based VPN

    Posted 12-05-2007 23:38
    for your Trust and Untrust interfaces, you are using NAT or ROUTE?


  • 4.  RE: Policy Based VPN

    Posted 12-06-2007 02:23
      |   view attached
    thank you rkim and chintag for taking care of this issue, well.. here is the configuration for the hub and spoke1.. spoke2 is the same is spoke1 so i didnt send it.

    the VPN is Active and UP on hun when i'm using RIP without enabling it on the trust interfaces, but its active and down on both spokes.

    i used static routes and worked fine, but i need to use RIP. the configuration is with static, if you want me to configure it as RIP and send it i will. thanks a lot.

    Attachment(s)

    zip
    Desktop.zip   2 KB 1 version


  • 5.  RE: Policy Based VPN
    Best Answer

    Posted 12-06-2007 10:43
    VPN shows active/down because VPN monitor is failing unless a route exists for the hub network. Out of curiosity, why are you using policy-based VPN for this? When using a dynamic routing protocol across VPNs, a route-based VPN is recommended. From the looks of your configs, I see no reason why you cannot use route-based. Due to the nature of RIP broadcasts or RIP/OSPF multicast, I don't recall either of these protocols work properly across policy-based VPNs.
     
    My recommendation is change this to a route-based VPN and apply RIP on the tunnel interfaces.


  • 6.  RE: Policy Based VPN

    Posted 12-08-2007 23:06
    thank you so much for the great info, your efforts are appreciated.