SRX

 View Only
last person joined: yesterday 

Ask questions and share experiences about the SRX Series, vSRX, and cSRX.
  • 1.  SRX210 Multicast PIM

    Posted 06-21-2017 17:41

    I have been able to pass multicast traffic from one srx210 to another and all works well in only one direction. Is there a way to pass the multicast trafic between srx's in both directions = senders and receivers on both internal subnets? Thanks inadvance for any help.


    #igmp
    #Multicast
    #PIM
    #SRX


  • 2.  RE: SRX210 Multicast PIM

     
    Posted 06-21-2017 19:47

    Hello,

     

    So if I understand correctly, you have multicast sources on each side.

    If that is the case, I am assuming they are sourcing traffic for distinct multicast group. Is that correct?

     

    Regards,

     

    Rushi



  • 3.  RE: SRX210 Multicast PIM

    Posted 06-21-2017 21:09

    If I am understanding correctly, yes.  Same group. The devices on the trusted internal networks of each one of the srx210's send and receive multicast traffic.  The group / multicast adress 225.8.11.8, is the same on all those devices.  It can changed, if needed.



  • 4.  RE: SRX210 Multicast PIM
    Best Answer

     
    Posted 06-21-2017 22:22

    Hello,

     

    If multicast group is same on the source on either side, why would devices behind SRX1 will use source which is behind SRX2 & vice versa?

     

    If multicast source behind SRX1 uses Group 1 while source behind SRX2 uses Group2, then it make sense & it can be achieved theoretically.

     

    Regards,

     

    Rushi



  • 5.  RE: SRX210 Multicast PIM

    Posted 06-22-2017 04:56
    It is for rf radio traffic. Srx1 site receives signal and multicasts it out
    to other sites (srx2, and srx3, etc), other sites receive multicast and
    need to be able to respond with multicast back to srx1 site - the same way.
    I am completely open to testing it the way you are thinking... Let's see if
    I am getting this right: srx1 site gets signal and multicasts it out in
    group 225.0.0.1, srx2 and srx3 sites receive and are able to respond back
    to srx1 site via multicast group 225.0.0.2.
    If I am understanding right, a multicast group per direction of traffic? If
    that would work, that would be great!


  • 6.  RE: SRX210 Multicast PIM

    Posted 06-23-2017 02:49
    Isn't PIM an ipv6 address. IGMP is ipv4 address.