Hi,
I'm currentlyu studdying for JNCIS-SP certification exam. I'm doing MPLS lab using Juniper VLAB. For my current lab I'm using the topology named "Segment Routing v6 [SRv6] Summarization"
In the ELearning documentation I read that if I run command "show route IP_ADDRESS detail" command I will get the weight of each route....
as shown here (from Juniper eLearning) (from MPLS RSVP module)
On real production router I'm getting similar information (the protocol in used may or may not RSVP but at the end the output is similar, I have metric value in decimal and weight value in HEX)
In my lab I have used ISIS as IGP and its and RSVP MPLS network. When I run "show route IP_ADDRESS detail" one one my PE router I don't have any weight value.
I'm going to attached my router configuration to this post and network diagram in PDF format.
Thank you
------------------------------
Xine
------------------------------