Switching

Hello everyone, currently using vqfx to configure erps has the following problems

[edit protocols]
'protection-group'
L2CPD : Unable to parse vlan-id-list for IFL xe-0/0/10.0
error: configuration check-out failed

This is the setting of erps

set protocols protection-group ethernet-ring RING1 guard-interval 2000
set protocols protection-group ethernet-ring RING1 east-interface control-channel xe-0/0/10.0
set protocols protection-group ethernet-ring RING1 west-interface control-channel xe-0/0/11.0
set protocols protection-group ethernet-ring RING1 control-vlan VLAN4090

This my configuration

set interfaces xe-0/0/10 mtu 9192
set interfaces xe-0/0/10 hold-time up 20000
set interfaces xe-0/0/10 hold-time down 0
set interfaces xe-0/0/10 unit 0 family ethernet-switching interface-mode trunk
set interfaces xe-0/0/10 unit 0 family ethernet-switching vlan members all
set protocols oam ethernet link-fault-management interface xe-0/0/10 apply-action-profile LFM_ACTION
set protocols oam ethernet link-fault-management interface xe-0/0/10 pdu-interval 1000
set protocols oam ethernet link-fault-management interface xe-0/0/10 pdu-threshold 10
set protocols lldp interface xe-0/0/10

This is the vlan setting

set vlans VLAN100 vlan-id 100
set vlans VLAN1100 vlan-id 1100
set vlans VLAN1101 vlan-id 1101
set vlans VLAN1102 vlan-id 1102
set vlans VLAN1103 vlan-id 1103.....to 4090

How to solve the problem, thanks for the answer

Attach the complete configuration file