Hi,
By default, you only can use PIC1 for VCP port, PIC0 is not supported for VCP. If you have additional extension module for the switch (PIC2), you may convert it to VCP port by running a command in operational mode.
You may refer to the Juniper official guide for more information.
Understanding EX Series Virtual Chassis
Juniper |
remove preview |
|
Understanding EX Series Virtual Chassis |
This topic introduces EX Series Virtual Chassis. An EX Series Virtual Chassis is a supported combination of interconnected EX2200, EX2300, EX3300, EX3400, EX4100, EX4100-F, EX4200, EX4400-24X, EX4400-24MP, EX4400-24P, EX4400-24T, EX4400-24X, EX4400-48F, EX4400-48MP, EX4400-48P, EX4400-48T, EX4300, EX4400, EX4600, EX4500, EX4550, or switches operating as one logical device and managed as a single chassis. |
View this on Juniper > |
|
|
i
------------------------------
LOW ZHE TING
------------------------------
Original Message:
Sent: 11-22-2023 14:05
From: MOHAMMED DAMOUH
Subject: Vitual chassis EX4400-24X
Hello everyone,
regarding an EX4400-24X switch, can a Virtual Chassis be formed using the 10G ports, or is it mandatory to use the 40/100G ports?
Thank you for your assistance.
------------------------------
MOHAMMED DAMOUH
------------------------------