It looks like Node 0 is secondary for Redundancy group 3 what interface do you ssh into?
Original Message:
Sent: 01-07-2024 19:16
From: RAYAN ALSAYED
Subject: Unable to SSH to Node 0 on CLuster SRX4100
Hi
node 0 (primary node) is not accessible using SSH after the switch update
I can ssh to node 1 (secondary node)
I can SSH to cluster and I can see both nodes are up
No automation was applied to the upgrade process
here is the cluster status:
============================================
Cluster ID: 1
Node Priority Status Preempt Manual Monitor-failures
Redundancy group: 0 , Failover count: 1
node0 254 primary no no None
node1 100 secondary no no None
Redundancy group: 1 , Failover count: 1
node0 254 primary no no None
node1 100 secondary no no None
Redundancy group: 2 , Failover count: 1
node0 254 primary no no None
node1 100 secondary no no None
Redundancy group: 3 , Failover count: 2
node0 254 secondary no no None
node1 100 primary no no None
Redundancy group: 4 , Failover count: 1
node0 254 primary no no None
node1 100 secondary no no None
------------------------------
RAYAN ALSAYED
Original Message:
Sent: 12-20-2023 12:17
From: JUAN RUIZ
Subject: Unable to SSH to Node 0 on CLuster SRX4100
Hi,
Which node in the cluster is the active one?
show chassis cluster status is the command. It is possible that during the EX update it caused a failover from node 0 to node 1. FYI this is an automation thread so was there any automation applied to the upgrade process?
------------------------------
JUAN RUIZ
Original Message:
Sent: 12-18-2023 18:12
From: RAYAN ALSAYED
Subject: Unable to SSH to Node 0 on CLuster SRX4100
Hi Team
I update the core switch EX4600 and after reboot, I got an alert saying that SRX Node 0 is down, I checked the cluster, both nodes are up and running
I tried to SSH to Node1, it works
I cannot SSH to Node 0
This occured right after updating the EX4600 to 21.4R3S5.4
Please advise
------------------------------
RAYAN ALSAYED
------------------------------