Hello Everyone,
Here is my question. Currently I have two Juniper SRX 300's that have a routing device between them, which then goes through a VPN. Also, my firewall global mode is currently set to switching under protocols.
The interface connected to the routing device uses INET and then I have an IRB interface with a private IP address which is assigned to a vlan that my other interface are assigned to.
EXMP:
GE-0/0/0 unit 0 family inet address 10.0.0.1/24
GE-0/0/1 unit 0 family ethernet switching interface mode access vlan members INSIDE
irb unit 0 family inet address 192.168.1.1/24
vlan INSIDE
vlan id 10
l3-interface irb.0
Both SRX's are configure very similar to what you see above, and when they are connected to either side of the VPN, I can ping the irb address, but I can't ping any device connected to ge-0/0/1 which is using the INSIDE vlan and has an ip address assigned to it within the same subnet as irb.0.
Is the reason I can't ping because the SRX is in global mode l2-learning switching? Is there something else I can do to get this to work?
p.s.
Zones and polices have also been set to allow traffic bi-directionally between the required zones.
Thanks,
Matt
------------------------------
MATTHEW LOVELAND
------------------------------