Hi
I have configured the Juniper devices as I expect them to ne configured for RADIUS authentication. Here is the configuration:
set system radius-server 192.168.10.1 secret "$9$SHyyMXVb2aGiYgi.fzCAIEcyvWX7-w24"
set system radius-server 192.168.10.1 source-address 195.80.0.13
set system login user remote full-name "RADIUS Authenticated"
set system login user remote uid 9999
set system login user remote class read-only
set system login user OP uid 2007
set system login user OP class operator
set system login user RO uid 2008
set system login user RO class read-only
set system login user SU uid 2009
set system login user SU class super-user
As far as I can make out from the documentation, this is all that should be required. However, I seem to be failing to get any authorisaiton whasoever from the RADIUS. So, my question is as follows:
Is the above configuration good? If it is then it is the free RADIUS that needs tweaking.... Just want to check if the config is correct.
Thanks