Routing

Hi guys,

I am facing a very unique problem. I have a mx10003 router and intending to use Port 0 and 2. Port 0 will have the breakout cables so I can get 4x10G links whereas Port 2 will be used as 40G.

I have the following configuration under the chassis.

fpc 0 {
    pic 0 {
        port 0 {
            speed 10g;
        }
        port 2 {
            speed 40g;
        }
    }
}

However, after coming the above config and resetting the PIC using the command.

request chassis pic pic-slot mic-slot-number fpc-slot fpc-slot-number (offline | online)

The PIC is not coming back online. It comes online for an instance and goes back offline immediately. Any idea what can be done here?

Many thanks!

Hi !

Please check the alarms : "show chassis alarms"

It will give you some idea.

Additionally refer this link :

https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/chassis-mx10003mpc-rate-select-configuring.html 

Regardless of the line card— MIC (PIC1) or fixed-port PIC (PIC0) installed —you must configureboth the PICs and all the associated ports, under the [edit chassis] hierarchy. Configuring ports on only one of the PICs results in an invalid configuration.

Please configure below command. 

set chassis fpc 0 pic 1 number-of-ports 0

Commit the conifg and reboot the FPC.

After the FPC boots up ; collect these command:

show chassis alarms

 show chassis fpc pic-status

show chassis pic pic-slot 0 fpc-slot 0

show chassis pic pic-slot 1 fpc-slot 0

Regards

Arpit