Hi
In Cisco BRAS, there is command which shows how many IP addresses are available in configured IP Pool and how many IP addresses are already in use.
Also there is a SNMP OID for this purpose.
I JMX BNG I could not find the counterpart command. The only command which I found just show which IP address was assigned to which Subscriber:
jcluser@vMX1> show network-access address-assignment pool POOL1
IP address/prefix Hardware address Host/User Type
192.168.120.2 00:0C:29:0B:FF:59 217625test2 pppoe
There is no information about number of available IP addresses in the POOL.
Also I tried following SNMP MIBS:
- jnxSubscriberMIB
- jnxpppoeMIB
but there was no success.
In some website this MIB was introduced:
Juniper-Address-POOL-MIB
But it seems this MIB is not supported on JMX
Is there any solution for this issue?
Thank you
Alireza