Junos OS

 View Only
last person joined: yesterday 

Ask questions and share experiences about Junos OS.
  • 1.  J-Web Quickconfiguration Setup

    Posted 09-22-2008 08:22
      |   view attached

    Hi people!

     

    I am new to Junos and want to step into Junos with the J-Web Quickconfiguration Setup.

     

    But I always get the error "source statement does not exist".

    I add a attachment with my settings.

     

    I can't see the problem.

     

    Thanks in advantage

    Best regards

    Macindy

    Message Edited by Macindy on 09-22-2008 08:24 AM

    #j-web
    #statement
    #source


  • 2.  RE: J-Web Quickconfiguration Setup

    Posted 09-23-2008 21:29

    I don't see anything obvious. What version of JUNOS and hardware platform? I personally tend to use CLI and not J-Web. But you may want to instead use Configuration > View & Edit instead of the Quick Configuration.

     

    -Richard



  • 3.  RE: J-Web Quickconfiguration Setup
    Best Answer

    Posted 09-24-2008 20:30

    The export version could definitely be your problem because you had selected SSH management. Export version only supports SSHv1 due to encryption levels available on export version. I believe that the  J-Web wizard defaults to SSHv2. I suspect that if had domestic version then you would likely not see an issue.

     

    At any rate I suspect that if you unchecked SSH then this may have worked as well.

     

    -Richard



  • 4.  RE: J-Web Quickconfiguration Setup

    Posted 09-23-2008 23:12

    Hi!

     

    I think its perhaps the export version, which makes trouble here.

    I switched to CLI and set the values here. Then it was no problem.

     

    Version: JunosES-9.2R1.10