This is wrong from my point of view. The dhcp-relay group should have the same name for the active-server-group and the interface.
set forwarding-options dhcp-relay group DHCP_Group_1 active-server-group DHCP_Server_1
set forwarding-options dhcp-relay group DHCP_Group_1 interface irb.10
set forwarding-options dhcp-relay group DHCP_Group_2 active-server-group DHCP_Server_2
set forwarding-options dhcp-relay group DHCP_Group_2 interface irb.20
Greetings
M
------------------------------
MICHAEL BAST
------------------------------
Original Message:
Sent: 05-08-2018 15:05
From: Erdem
Subject: IP Helper Configurations
Hi Experts,
I need to convert IP helper configuration from a Cisco core switch to a Juniper EX9200 switch. Can you please confirm if this configuration is correct?
VLAN 10 mapped to irb.10 and VLAN 20 mapped to irb.20.
Cisco Config:
Cisco SWITCH#sh run int vlan 10 | i helperip helper-address 10.10.50.100Cisco SWITCH#sh run int vlan 20 | i helperip helper-address 10.10.100.100Cisco SWITCH#
Juniper config:
set forwarding-options dhcp-relay server-group DHCP_Server_1 10.10.50.100set forwarding-options dhcp-relay server-group DHCP_Server_2 10.10.100.100set forwarding-options dhcp-relay group DHCP_Group_1 active-server-group DHCP_Server_1set forwarding-options dhcp-relay group DHCP interface irb.10set forwarding-options dhcp-relay group DHCP_Group_2 active-server-group DHCP_Server_2set forwarding-options dhcp-relay group DHCP interface irb.20