Message Image

Skip main navigation (Press Enter).

SRX

View Only

last person joined: yesterday

Ask questions and share experiences about the SRX Series, vSRX, and cSRX.

Back to discussions

Expand all | Collapse all

IKE negotiation failed with error: Timed out

Koos14701-21-2023 14:26

Good day, i tried to establish a tunnel with a draytek, the draytek is using 4G with a dynamic ip (no ...

spuluka01-24-2023 19:09

The full step by step check process is outline with this kb. https://supportportal.juniper.net/s/article/SRX-Resolution-Guide-How-to-troubleshoot-Problem-Scenarios-in-VPN-tunnels ...

spuluka01-30-2023 12:18

the key here will be to get more detailed messages. Try this logging configuration found in the second ...

Brijil01-24-2023 22:15

Hello, Instead of configuring "hostname casa-fw01.fnetonline.local" on SRX device configure below: ...

Koos14701-25-2023 10:14

Thanks for your aswers. @spuluka I have seen the sites. but there is no mention of a timeout. ...

Brijil01-25-2023 21:27

Hello, The timeout could be occurring because the SRX is failing to identify the peer. So we can ...

Koos14701-28-2023 13:01

Good evening, did some more tests. to rule out the dynamic hostname etc. i set the public adres. ...

Koos14702-19-2023 15:23

Got an different (way older) model of draytek. build the config from scratch. and again the same ...

spuluka02-19-2023 20:22

This is indicating that the Draytek is a responder mode and not giving a reply. So the detail ...

T_J06-19-2023 09:57

Hi all. I am experiencing a similar issue but with a different vendor. On the other side, I have ...

spuluka06-19-2023 10:35

The Open gear message seems to indicate that either the preshared key does not match or the two ...

T_J06-20-2023 02:22

Hi, I tried retyping my PSK several times, but the result was the same. Then I decided to ...

bkamen06-20-2023 04:32

Hey TJ. Ok - so you're sure about the PSK (even if it's simple for now) -- but what about ...

T_J06-21-2023 10:25

Hi, On my juniper srx I have static IP but on Opengear I have dynamic. here is my configuration: ...

spuluka06-20-2023 07:03

I would avoid the slashes and use other special characters instead. These can be misinterpreted ...

1. IKE negotiation failed with error: Timed out

0 Recommend

Koos147

Posted 01-21-2023 14:26

Reply