Switching

 View Only

  • 1.  Configure two ports one is active and the second is passive or standby

    Posted 03-29-2023 05:54

    Hello , 

    I have two ports on Juniper switch connected to two ports on one Mikrotik router  as a bridge and I want to configure the two ports on Juniper to be active and standby or active and passive because this Juniper Switch is stacked for redundancy so the idea if I lost connection with the first link I can use the second 

    Can any one help me with the configuration I need to do ? 

    You can see the diagram in the attachments

    Best Regards  



    ------------------------------
    Zurratos Zurratos
    ------------------------------


  • 2.  RE: Configure two ports one is active and the second is passive or standby

    Posted 03-30-2023 04:52

    Hi,

    If u do bundle then u can make it active-passive physical.

    Thanks




  • 3.  RE: Configure two ports one is active and the second is passive or standby

    Posted 03-31-2023 05:52

    Hi,

    I can see your juniper devices are in a VC(virtual chassis) you can configure link aggregation which will bundle both links into one which will give you bandwidth by merging both interface as well if one link goes down other will be still working.

    you can go thourgh juniper documentation for configuring link aggregation.

    Regards,
    Nithin J



    ------------------------------
    Nithin J
    ------------------------------