Hi,
This alarm is generated because I believe you changed the port speed on the port and did not reset the MIC for it to take effect. Something like this:
fpc 3 {
pic 0 {
port 0 {
speed 100g; <<<
}
port 1 {
speed 100g;
}
port 2 {
speed 10g;
}
According to our documentation it is mandatory to either reset the MPC or MIC when port speed is changed on MPC7, MPC8 and MPC9:
|
Note: When you change the port speed at the port level, you must rest the MPC for the configuration to take effect. Because resetting the MPC takes several minutes and since it affects all the PFEs, you can choose to use the request chassis mic mic-slot mic-slot-number fpc-slot fpc-slot-number (offline | online) command to reset the MIC and apply your configuration changes. An alarm is generated indicating the change in port speed. For guidelines on configuring rate selectability, see Guidelines for Configuring Rate Selectability.
|
In your case if you have changed the port speed on any port of FPC3, then you can use the following command to clear it:
request chassis mic mic-slot 0 fpc-slot 3 offline
request chassis mic mic-slot 0 fpc-slot 3 online
Following are the documentation links for your reference:
https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/chassis-mic-mrate-rate-selectability-configuring.html
https://www.juniper.net/documentation/en_US/junos/topics/reference/general/rate-selectability-guidelines.html
Hope this helps
--------------------------------------------------------------------------------------------------------
If this post was helpful, please mark this post as an "Accepted Solution".
Kudos are always appreciated!
--------------------------------------------------------------------------------------------------------