SRX Next-Gen Firewalls

Perhaps the rule of thumb applies here that you cannot get past what seemingly looks like an operator type error. When I say operator I mean the => operator. If immediately after follows a 0 at some point we are sure that is an integer error. If it's ...

This message was posted by a user wishing to remain anonymous Nikolay Semov , thank you for reaching out. I have seen that link before, but unfortunately, it doesn't address my specific issue. I've had similar situations where the device would ...

ISP1 and ISP2 are connected via the internet. They should be able to reach each other. In your configuration snippet, it looks like you're importing interface routes (a.k.a. Direct routes) into New-route-table. If that's the case, then traffic going ...

Nikolay, " And in any case, I also don't see how pinging gateway addresses from an external device (your phone) is relevant to your original question about Filter-Based Forwarding." If both paths, ISP1 and ISP2 can discover a way to the Gateway ...

Sounds like hard reset or contacting Juniper for this one: https://supportportal.juniper.net/s/article/SRX-Stuck-at-boot-stage-3-after-attempting-a-Routing-Engine-BIOS-U-boot-firmware-upgrade?language=en_US ------------------------------ Nikolay Semov ...

I'm getting lost a little bit in what you mean about "finding" "it," " local static route," and other aspects. Your configuration snippet is extremely limited, so I'm not sure I have a good picture of what you're dealing with and what you're trying to ...

This message was posted by a user wishing to remain anonymous Hello , I am currently experiencing an issue with my Juniper SRX300 device. Upon booting, I encounter errors related to the SPI stage 3 bootloader. Below are the details of the ...