SRX Next-Gen Firewalls

As Ryota notes the use of aggregate route for this application. The other option is the generate route. With the aggregate route the larger prefix is available for advertising if any subnet of this is active in the table. With the generate route ...

Dear Community, Greetings to all. We are a data center that utilizes Juniper routers and switches across our entire network infrastructure. To protect against potential L3/L4 DDoS threats originating from outside the country, we are currently using ...

Hi > Is it possible for me to be able to break up this IP block but still advertise the full /24 to our ISP to be able to maintain BGP with them? Yes, it is possible. I recommend you to use "Route Aggregation". When smaller subnet is in routing ...

Forgive the noob question, it's been many years since my CCNA courses. We just got a /24 ip block. Our ISPs are able to provide us BGP and the smallest network they will advertise is a /24. As a start we created a DMZ interface and assigned the ...

Hey guys, I currently have an SRX345 active/passive chassis cluster. The node 0 is an SRX345-SYS-JB-2AC and the node 1 is an SRX345-SYS-JB. I will be replacing the node 1 with the 2AC model. I was looking over the [SRX] RMA replacement of a node in ...

All addresses for policies are created in the Configure ->Shared Objects -> Addresses section and then referenced in the policies created in each of the zones. One exception is when setting up NAT addresses. The NAT pools are under Configure->NAT Policy->Pools. ...

This message was posted by a user wishing to remain anonymous That was it. Thank you!