SRX Next-Gen Firewalls

You would use the irb interfaces as the gateway address for the two vlans to insure that all traffic between the vlans does transit the SRX. These interfaces, not the layer 2 interfaces are what you would assign to the security zones. Then you would ...

Hi John, These are the steps to enable DNS Security on the SRX. Enroll device to ATP cloud, ensure that device has premium license for ATP cloud. https://www.juniper.net/documentation/us/en/software/sky-atp/atp-cloud-admin-guide/topics/task/sky-atp-device-enrolling-srx-only.html ...

This message was posted by a user wishing to remain anonymous Dear Team, I have a SRX300 (no configuration) and I need to limit access the resources from VLAN 1 to VLAN 2 . I need to assign a Native VLAN on each SRX ports for each VLANs (two ports ...

While it is possible (I did this once to just try it years ago) to connect SRX cluster nodes to each other via switches. It is really not recommended. You need to make the control and fabric links their own VLAN's. Turn off LLDP/CDP/NDP or anything ...

This message was posted by a user wishing to remain anonymous Remote accessVPN with SecureConnect is working well for both mobile & desktops on SRX380 with JUNOS 21.4-R3 version. However, it's not allowing simultaneous login for the same user using ...

I've been advised that running the control link must be direct between the two nodes and not via a switch. I assume this means there is either some special non-ethernet signaling or large mtu involved. But the troubleshooting article just says connect ...

I have a setup where there are two locations, each having an SRX1500 and an EX4650 switch. The SRX1500s are supposed to form a cluster, but I'm facing an issue with the control link. Here's a detailed breakdown: At location 1, the SRX (srx-location1) ...