SRX Next-Gen Firewalls

Can you do a trace route and determine where the path fails? I suspect one of two issues: The routing from the reth3 gateway onward is not working. The source nat rules on the reth3 internet path to not allow the translation of the mgmt VR ip address ...

Hello , I have cluster of SRX 380 , I have setup two mgmt_junos.inet.0: 3 destinations, 3 routes (3 active, 0 holddown, 0 hidden) + = Active Route, - = Last Active, * = Both 0.0.0.0/0 *[Static/5] 00:17:31 ...

Well, turns out that I just needed to call Verizon and have them refresh the line, since all my configs were correct to begin with.

There are a couple of how-tos out there with reference to Dual ISP WAN setup, including several within the Juniper community forum. We're not load balancing our outbound traffic, but we do have dual ISP setup, so I thought I'd share what's currently ...

Thanks Marc, next-hop dl0.0 was my original configuration, so yes, I've tried that as well. I'm still not getting anything back, which is why I'm so stumped. I'm getting full on IP address on the LTE interface, so seems like all should be working ...

Thank you very much for your quick reply. I also assumed so according to the documentation, but I had to check because these two models seemed somewhat similar to me. It's much clearer to me now.

Hi, if you want to test your lte connection.. you need to change your default route.. it is now pointing to a default behind a ge interface. route 0.0.0.0/0 next-hop dl0.0 should make you be able to reach 8.8.8.8. Disable or remove the default ...