SRX Next-Gen Firewalls

 View Only
last person joined: 20 hours ago 

Ask questions and share experiences about the SRX Series, vSRX, and cSRX.


If you have a question or a use case, likely there are others who are experiencing or worked through the same thing. Don't hesitate to jump in and ask or share your knowledge!

Need additional guidance?  Check out these Juniper Resources.

Juniper Threat LabsSRX Upgrade Guide Security Advisories Technical Bulletins

Latest Discussion Posts

  • Profile Picture

    RE: SkyATP

    Okay, thanks. Because I've had it activated for a good week and I haven't seen any special upturns since the boxes were activated. On the J-Web part, SecIntel sends back blocking information with the info "cc_ip_data", will it be the same with the activation ...

  • Hi, As per im understand Pulse Secure client no longer support in SRX start some junos version. Thanks

  • Hey all, I'm configuring a new SRX300 and everything else is done except for the dynamic VPN users which will be using Pulse Secure. Looks like the syntax of the config has changed (again) and I'm struggling to find a good link describing what to ...

  • Profile Picture

    RE: SkyATP

    This message was posted by a user wishing to remain anonymous You don't have to explicitly create rules for these feeds, srx will check against all feeds enabled on Sky. When you get a block, the SecIntel log message contains the feed that the block ...

  • Hi , I used SRX380 to establish a cluster. After confirming that it was normal, I inserted two SFP and two SFP+. The original plan was to set reth to xe-0/0/17 xe-0/0/18, but it was deleted for other reasons and replaced with ge-0/0/14 ge-0/0/15. ...

  • Profile Picture

    RE: SkyATP

    Hello, Thank you for your feedback, I did have this link. However, the documentation doesn't mention the configuration to activate "Block List" or "DShield" for example. We already have a functional configuration for CC and Infected Hosts but I ...

  • Hi Steve, Thank you for your response. Currently, I have implemented an RPM probe to deactivate and reactivate the secondary link (ge-0/0/0) using below mentioned command. If feasible, please review my configuration and recommend appropriate adjustments ...

Unanswered Posts

Top Contributors in the Community