I have an ae interface setup on an EX4500. However when I do a run show interfaces terse it does not show up. When I try show interfaces ae0 terse the following error pops up: error: device ae0 not found. Has anyone come across this in Junos 11.1R1.10?
Hey Will - you did not state if it ever worked or not. So consider this my "dumb" question of the day to you. When you define an aggregated ethernet I/F you must first created it logically by setting the following:
user@host# set chassis aggregated-devices ethernet device-count X <where "X" equals the number you want to create>
If you do this then when you do an operational show you will then see the I/F <In a down state if no other config is done yet>. As you are getting an error on the show command I am wondering if this step was left out.
Thanks for pointing out what should have been obvious. ae interfaces are up and running.