The general process for what you want is as follows.
- The gateway ip address moves from a physical interface to a virtual one vlan.#. <<<< chosen unit number with the family inet address which seems currently on your ge-0/0/2 interface
- All the interfaces added to a chosen vlan
- The vlan.# interface added to the desired zone and existing interface removed
- dhcp setup normally
There might be some limitations on the card. I can't find the documentation off some quick searches but I do recall there are some features that cannot be used on this card ports due to the way the chip set is connected. But can't find the details.
Steve Puluka BSEET - Juniper Ambassador
IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)http://puluka.com/home
Sent: 01-20-2022 09:34
From: Unknown User
Subject: Enabling Ports on XPIM
I recently received a 24 port gig-e XPIM for my SRX650. I have been having troubles implementing it into the network. My goal is to have it function as part of the Users zone which is also available on ge/0/0/2 and just have it function as a simple 24 port switch, in which all ports work as a simple ethernet for Users with J-web management interface enabled on 10.1.0.1 and DHCP assigning 10.1.0.0/16 addresses.
Currently, I have created logical interfaces, which I have pointed towards the Users zone. This doesn't seem to be working, as even after enabling DHCP on those ports (under security -> zones), and setting a management IPv4 I cannot get an assigned IP, and with static, I cannot either access the internet. On the 0/0/2 I have the IP set to 10.1.0.1/16, and then on the new XPIM logical interfaces, I have them set as 10.1.0.2, ...3, ...4 etc... Is this the correct way of setting this up? The only other thing I can think of is a VLAN, which I don't entirely understand how to do on the SRX650, as it tells me "ethernet-switching family not allowed on srx650:on-board gig-e" even if I disable 0/0/2 as one of the chosen ports.
Please let me know if there's further information needed from me. I'm running 12.3X48-D101.
Thank you for your help, I'm quite novice at using JunOS and really appreciate the assistance.