Hello,
I have an SRX220 that has been unstable, as it appears to go offline and restart at various times, on it's own! Based on my system parameters below, do I need to update my BIO's to 2.8? Do I need to also look into my file system boot-messages WARNINGS?
Lastly, what about the snapshot media internal files, Primary vs Backup.
Should they be matching versions?
Please do let me know.
V/r,
Scott
ScotTn3T@RTAEEC02> show system software
Information for junos:
Comment:
JUNOS Software Release [12.1X46-D65.4]
ScotTn3T@RTAEEC02> show chassis routing-engine bios
Routing Engine BIOS Version: 2.5
Part Type Tag Current Available Status
version version
Routing Engine 0 RE BIOS 0 2.5 2.8 OK
Routing Engine 0 RE BIOS Backup 1 2.5 2.8 OK
ScotTn3T@RTAEEC02> show chassis routing-engine
Routing Engine status:
Temperature 49 degrees C / 120 degrees F
Total memory 2048 MB Max 1044 MB used ( 51 percent)
Control plane memory 1088 MB Max 490 MB used ( 45 percent)
Data plane memory 960 MB Max 547 MB used ( 57 percent)
CPU utilization:
User 6 percent
Background 0 percent
Kernel 11 percent
Interrupt 0 percent
Idle 83 percent
Model RE-SRX220H2-POE
Serial ID ACKK8341
Start time 2021-09-30 13:08:14 EDT
Uptime 1 day, 10 hours, 58 minutes, 36 seconds
Last reboot reason 0x1:power cycle/failure
Load averages: 1 minute 5 minute 15 minute
0.07 0.11 0.08
ScotTn3T@RTAEEC02> show system boot-messages
kld_map_v: 0x8ff80000, kld_map_p: 0x0
Copyright (c) 1996-2016, Juniper Networks, Inc.
All rights reserved.
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
JUNOS 12.1X46-D65.4 #0: 2016-12-30 01:34:30 UTC
builder@quoarth.juniper.net:/volume/build/junos/12.1/service/12.1X46-D65.4/obj-octeon/junos/bsd/kernels/JSRXNLE/kernel
JUNOS 12.1X46-D65.4 #0: 2016-12-30 01:34:30 UTC
builder@quoarth.juniper.net:/volume/build/junos/12.1/service/12.1X46-D65.4/obj-octeon/junos/bsd/kernels/JSRXNLE/kernel
real memory = 2147483648 (2048MB)
avail memory = 1057017856 (1008MB)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
Security policy loaded: JUNOS MAC/pcap (mac_pcap)
Security policy loaded: JUNOS MAC/runasnonroot (mac_runasnonroot)
netisr_init: !debug_mpsafenet, forcing maxthreads from 2 to 1
cpu0 on motherboard
: CAVIUM's OCTEON 5020 CPU Rev. 0.1 with no FPU implemented
L1 Cache: I size 32kb(128 line), D size 8kb(128 line), sixty four way.
L2 Cache: Size 128kb, 8 way
obio0 on motherboard
uart0: <Octeon-16550 channel 0> on obio0
uart0: console (9600,n,8,1)
twsi0 on obio0
dwc0: <Synopsis DWC OTG Controller Driver> on obio0
usb0: <USB Bus for DWC OTG Controller> on dwc0
usb0: USB revision 2.0
uhub0: vendor 0x0000 DWC OTG root hub, class 9/0, rev 2.00/1.00, addr 1
uhub0: 1 port with 1 removable, self powered
uhub1: vendor 0x0409 product 0x005a, class 9/0, rev 2.00/1.00, addr 2
uhub1: single transaction translator
uhub1: 3 ports with 2 removable, self powered
cpld0 on obio0
pcib0: <Cavium on-chip PCI bridge> on obio0
Disabling Octeon big bar support
PCI Status: PCI 32-bit: 0xc041b
pcib0: Initialized controller
pci0: <PCI bus> on pcib0
pci0: <simple comms> at device 1.0 (no driver attached)
atapci0: <SiI 0680 UDMA133 controller> port 0x8-0xb,0x10-0x17,0x18-0x1b,0x20-0x2f mem 0x8020000-0x80200ff irq 0 at device 2.0 on pci0
ata2: <ATA channel 0> on atapci0
ata3: <ATA channel 1> on atapci0
gblmem0 on obio0
octpkt0: <Octeon RGMII> on obio0
cfi0: <AMD/Fujitsu - 8MB> on obio0
Timecounter "mips" frequency 700000000 Hz quality 0
###PCB Group initialized for udppcbgroup
###PCB Group initialized for tcppcbgroup
ad0: Device does not support APM
ad0: 2000MB <CF 2GB 20100924> at ata2-master WDMA2
Trying to mount root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted
WARNING: / was not properly dismounted
WARNING: R/W mount of /cf/var denied. Filesystem is not clean - run fsck
ScotTn3T@RTAEEC02> show system storage partitions
Boot Media: internal (ad0)
Active Partition: ad0s1a
Backup Partition: ad0s2a
Currently booted from: active (ad0s1a)
Partitions information:
Partition Size Mountpoint
s1a 619M /
s2a 620M altroot
s3e 49M /config
s3f 615M /var
s4a 54M recovery
s4e 5.6M
ScotTn3T@RTAEEC02> show system snapshot media internal
Information for snapshot on internal (/dev/ad0s1a) (primary)
Creation date: Sep 30 13:08:22 2021
JUNOS version on snapshot:
junos : 12.1X46-D65.4-domestic
Information for snapshot on internal (/dev/ad0s2a) (backup)
Creation date: Nov 16 19:21:03 2015
JUNOS version on snapshot:
junos : 12.1X46-D35.1-domestic
------------------------------
Scott Lucas
------------------------------