Data Center

IMPORTANT MODERATION NOTICE

This community is currently under full moderation, meaning  all posts will be reviewed before appearing in the community. Please expect a brief delay—there is no need to post multiple times. If your post is rejected, you'll receive an email outlining the reason(s). We've implemented full moderation to control spam. Thank you for your patience and participation.



  • 1.  Using 120v and 240v Mains to Power A QFX Chassis

    Posted 10-19-2021 12:28
    Hello,
    I can't find this info anywhere else, so I'll try it here.
    I currently have 3 QFX routers running dual PS powered by 120vac mains.
    I want to migrate the power from 120vac to 240vac without interrupting the service.
    My question is, can I move 1 PS at a time from 120vac to 240vac without causing problems?
    In other words, will the system support 2 power supplies powered by 2 different mains voltages?

    Thanks.

    ------------------------------
    Mark Rawson
    ------------------------------


  • 2.  RE: Using 120v and 240v Mains to Power A QFX Chassis

     
    Posted 10-19-2021 18:54
    I have not run QFX devices, but have been told NOT to do that mixed power input setup on MX and SRX devices.

    So I would assume it would be the same here.

    ------------------------------
    Steve Puluka BSEET - Juniper Ambassador
    IP Architect - DQE Communications Pittsburgh, PA (Metro Ethernet & ISP)
    http://puluka.com/home
    ------------------------------